Mafell K 85 Ec Traduccion Del Manual De Instrucciones Originale página 29

5.8 Working with the roller edge guide
The roller edge guide serves to work parallel to an
already existing edge. The limit stop can be attached
to the left or right of the machine. The cutting range on
the right-hand side amounts to approx. 12 - 48 mm
(15/32 – 1 57/64 in.) and on the left-hand side to
approx. 40 – 280 mm (1 37/64 – 11 15/64 in.).
• You can adjust the cutting width after releasing the
wing screws 9 (Fig. 2) by moving the limit stop
accordingly and afterwards retightening the wing
screws.
7 Troubleshooting
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
please contact your dealer or the MAFELL customer service directly.
Defect
Machine cannot be switched on
Machine stops while cutting is in
process
Danger
Determining the causes for existing defects and eliminating these always requires
increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage or mains
voltage too low
Mains fuse defective
Carbon brushes worn
Mains failure
Machine overloaded
Carbon brushes worn
6 Service and maintenance
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.
6.1 Storage
Clean the machine thoroughly if the machine is not
used for a longer period of time. Spray blank metal
parts with a rust-proofing agent.
-29-
Danger
Pull the power plug during all
service work.
Elimination
Have power supply checked by
an electrician
Have fuse replaced by an
electrician
Take the machine to a MAFELL
customer service shop
Have mains-side pre-fuses
checked by an electrician
Reduce feed speed
Take the machine to a MAFELL
customer service shop