cecotec ENERGYSILENCE AERO 4600 HELICOPTER Manual De Instrucciones página 46

ENGLISH
3. PRODUCT ASSEMBLY
Installation of the mounting bracket
- Concrete ceiling. Fig. 2
- Wooden ceiling. Fig 3
Drill a φ8 mm hole in the concrete ceiling and insert the bolt. Align the bracket with the hole
and tighten it with a nut.
1. Choose the length of the downrod depending on the ceiling on which the fan is to be placed.
2. Remove the downrod from the box, remove the safety pin and the downrod clip. Fig. 4
Fig. 4 key
1. Power cable
2. Canopy
3. Downrod
4. Coupling cover
5. Clip
6. Screw assembly 1
7. Screw assembly 2
8. Clevis pin
9. Connecting head
3. Insert the downrod into the canopy and the coupling cover, then pass the power cable
through the downrod.
4. Insert the downrod into the central hole of the connecting head. Then insert the clip and
clevis pin previously removed from the downrod. Next, tighten the screw and lower the
coupling cover. Fig. 5
NOTE: the fan blades must be positioned at least 2.3 metres above the ground.
Warning: it is very important that the clevis pin is correctly positioned and that the screws are
properly tightened. Otherwise, the fan may fall down.
Assembling the blades
Fig. 6.
1. Remove the motor screws and set them aside to use them in the next step.
2. Place the blade bracket on the motor assembly. Next, tighten the screws.
3. Place the blades on the bracket and fix them using the screws.
46
ENERGYSILENCE AERO 4600 HELICOPTER