cecotec ENERGYSILENCE AERO 4600 HELICOPTER Manual De Instrucciones página 48

ENGLISH
3. The connecting bolt must be inserted into the fixing seat slot.
Remote control connection
Warning: to avoid the risk of electric shock, be sure to disconnect the main power supply to the
switchboard before connecting the cables.
Once the fan has been hung, insert the receiver into the recess of the mounting bracket so that
the remote control can operate correctly and receive commands, as shown in figure 11.
Receiver wiring
Cable connection diagram. To connect the cables, follow the diagram in figure 12.
Fig. 12 key
Earth
1. Mounting bracket
2. Terminal block
3. Controller input cable assembly
4. Remote control receiver
5. Light input cable assembly
6. Motor input cable assembly
Warning
- Before handling the cables, make sure all the poles are disconnected from the power
supply.
- The fan includes a remote-control unit with radio frequency, it does not have a speed
control chain. It can only be controlled through the remote control inside the box.
- 2 people are needed to carry out the cable connection step. It is suggested that 1 person
holds the assembled device while the other one connects the cables.
Installing the canopy
Fig. 13
1. Lift the canopy up to the mounting bracket, aligning the screws in the mounting bracket
with the holes in the canopy.
2. Re-insert the screws and secure them all with a screwdriver.
Once you have secured the mounting bracket to the connection cover, you can hang the fan.
Tip: have someone else hold the ladder securely and bring the fan closer to you once it is on
the ladder.
48
ENERGYSILENCE AERO 4600 HELICOPTER