Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the LED light
Fig. 14
1. To complete the installation, place the lamp in its bracket.
2. Next, place the lampshade on the LED plate, and secure them with decorative clips and
bolt nuts.
4. OPERATION
This fan can be operated with the remote control.
NOTE: turn on the receiver and press the Light on/off button on the remote control once. If you
hear two beeps, it means that pairing has been made successfully.
Remote control
Fig. 15
1. Receiver operation indicator light.
2. Buttons for switching on the fan at the desired speed. 6 speeds available to regulate the
intensity of the air flow.
3. Off button.
4. Reverse rotation button. A motor reversing system is available to provide the summer/
winter function. Rotating in one direction, you can enjoy a pleasant breeze in summer, and,
in the opposite direction, the fan will blow warm air to the floor and complement your
heating system in winter.
5. Natural Breeze button. It allows for the 6 speeds to be randomly interchanged.
6. Light button. You can switch the light on and off to create the perfect atmosphere.
7. Timer button. Up to 8 hours of operation can be selected, after which the fan will switch
off.
NOTE: once you press the timer button, do not press any other button. Otherwise, the function
will be cancelled.
Note
-
If the remote control cannot control the receiver, check if the batteries make contact, if they
are inserted correctly and if they are not flat.
-
If the remote control cannot control the receiver, check if there are other appliances
operating with a remote control nearby, as they may cause interference. If you remove
these appliances from the room where the fan is located, the remote control will work
properly again.
-
Use this appliance with the correct voltage. If the voltage is too low, the remote control
will not work.
-
If you are not going to use the remote control for a long period of time, remove the batteries.
ENERGYSILENCE AERO 4600 HELICOPTER
ENGLISH
49
Publicidad
