Pioneer ND-PG1 Manual Del Propietário página 14

Installing the sensor unit
Installation
Stick the supplied Velcro tape (hard type) to the bottom of the sensor unit, and stick the
Velcro tape (soft type) to the selected location for installation.
Precaution:
• Make sure the surface is free of moisture, dust, grime, oil, etc. before sticking Velcro tape.
Stick on the Velcro tape (hard
type) making sure not to cover
the seals on the bottom of the
sensor unit.
Note:
• When sticking Velcro tape (hard type) to a car mat, you can install the sensor unit directly to the
mat. In this case, do not use the soft type of Velcro tape.
13
Velcro tape (hard type) × 2
Bottom of the sensor unit
Sensor unit
Velcro tape (soft type) × 2
Flat surface