Hella Gutmann SEG V Manual Del Usuario página 121

Hella Gutmann
• Rails are mounted onto the ground.
• When used as a rail unit, you need to order a rail set for each SEG V (ord. no. 9XS 861 736-001). The rail serves as a
drill template during assembly.
Moreover, we offer an adjustable rail system (order no.: 9XS 861 736-021) and a caster set (order no. 9XS 862
004-021).
• To establish the vehicle setup area, the same conditions apply as described in the section Requirements for Vehicle
Setup Area and SEG V [} 118].
To test and adjust headlights observe the following when running the rails:
• The vehicle floor surface and rail level for the SEG V must lie parallel to each other in both dimensions.
• The height difference of the caster running surface must correspond to legal specifications.
• The rails (order no.: 9XS 861 736-001) must entirely rest onto the surface, so that they cannot bend.
• The rails are positioned in pairs 90° to the vehicle's longitudinal axis. Prevent lateral displacements on rails that col-
lide (fig. 4).
NOTICE
If the device is placed onto guide rails you need to add or respectively subtract the height measure accord-
ingly.
The tape measure is available as spare part and can be attached to the post accordingly.
8.2.3. Vehicle Test
NOTICE
Observe complete regulation, §29 of the German Road Traffic Licensing Regulation.
Observe national regulations.
Observe the manufacturer's specifications.
NOTICE
The SEG V can be used to test all headlight systems, including DE, FF, LED and xenon headlights. Headlights
must be fastened to the vehicle after adjustment such that unintended adjustment cannot occur. After re-
pairs are made to the vehicle suspension, the headlight aiming shall be tested. This is also recommended af-
ter changing a headlight bulb.
• Tires have the prescribed air pressure.
• The headlight lenses are not damaged or dirty.
• The headlights are checked for good working order.
SEG V
Working with the Device | 8.
121