Hella Gutmann SEG V Manual Del Usuario página 132

8. | Working with the Device
15. If required, change the data as described in the section Configuring Vehicle Data [} 102].
16. Open the Headlight selection window with
17. Perform the headlight test as described in the section Performing headlight test [} 135].
18. Use to call up the selection window Finish documented test?.
19. Use the selection window to:
finish the measurement
finish the measurement and send it to the pen drive
finish the measurement and send it per e-mail
NOTICE
The message Finish measurement and send it per e-mail is only indicated if the Wi-Fi interface is config-
ured.
20. Regard the window with information and instructions.
21. Finish the measurement with
22. Abort the procedure with
ð The data from the documented test are automatically saved in Car History.
8.4.6. Creating a Report
The report of the documented test can be saved on a pen drive or it can be sent per e-mail to another device.
To save the report on a pen drive, proceed as follows:
1. Insert a pen drive into the USB port on the SEG V.
2. Perform the steps 1 to 6 as described in section Performing Documented Tests from the Car History [} 129].
3. Select >Send report<.
The report is saved as a PDF file on the pen drive.
The report contains the following information:
• Company data
• Customer and vehicle data
• Device type
• Date and time of the headlight test
• Test results before headlight adjustment
• Test results after headlight adjustment
132
.
.
.
Hella Gutmann
SEG V