Balluff BTL7-P511-M S115 Serie Manual De Instrucciones página 35

BTL7-P511-M _ _ _ _ -BE/BF/CE/ZE/ZF-S32/S115/KA _ _ /FA _ _
Magnetostrictive Linear Position Sensor — Rod Style
4
Installation and connection (continued)
Magnet
(e.g. BTL-P-1028-15R)
Supporting rod made of non-magnetizable material
Fig. 4-9: Example 2, BTL installed with supporting rod
4.4 Electrical connection
Depending on the model, the electrical connection is made
using a cable or a connector.
The connection or pin assignments for the respective
version can be found in Tab. 4-2 to Tab. 4-3.
Note the information on shielding and cable
routing on page 12.
4.4.1 Connector S32/cable
S32 Wire color
Pin
1
YE yellow
2
GY gray
3
PK pink
4
RD red
5
GN green
6
BU blue
7
BN brown
8
WH white
1) Unassigned leads can be connected to the GND on the controller side
but not to the shield.
Tab. 4-2: Connection assignment BTL7...-S32
Fig. 4-10: Pin assignment of S32 (view of connector pins of BTL),
8-pin M16 circular plug
www.balluff.com
Interface
BTL7-P511...-S32/cable
+Init
+Start/stop
–Init
Not used
1)
–Start/stop
GND
10...30 V
Not used
1)
4.4.2 Connector S115
S115 Interface
Pin BTL7-P511...-S115
1 +Init
2 +Start/stop
3 –Init
4 Not used
1)
5 –Start/stop
6 GND
7 10...30 V
8 Not used
1)
1) Unassigned leads can be connected to the GND on the controller side
but not to the shield.
Tab. 4-3: Connection assignment BTL7...-S115
Fig. 4-11: Pin assignment of S115 (view of connector pins of BTL),
8-pin M12 circular plug
english 11