Publicidad
Idiomas disponibles
Idiomas disponibles
insert the fuel tank key, rotate it clockwise, and pull
open the fuel tank cap together with the key. Upon
completion of refueling, align the fuel tank cap with its
guide pin and press it downward to close the fuel
tank cap. Remove the key after a locking sound
occurs, and close the dust cover of the fuel tank cap.
Do not overfill the fuel tank (it
is recommended that the fuel
tank should be filled up to 90%
of the fuel tank capacity). For
refueling, do not exceed the
MAX mark of the fuel tank as
shown in the figure below. And do not splash fuel on
the hot engine; otherwise, the motorcycle may run
abnormally or dangerous accidents may occur.
When refueling, turn off the engine and turn the igni-
tion switch to the "
" (off) position.
Lock the fuel tank cap after refueling to prevent
excessive evaporation of fuel into the atmosphere,
which wastes energy and pollutes the environment.
Smoking or open flames are strictly prohibited when
refueling.
If gasoline overflows into the carbon canister and
other parts and components, clean or replace the
canister as soon as possible at the QJMOTOR Ser-
vice Center, because excessive gasoline entering
the canister will cause the activated carbon to fail
prematurely.
Always check that the fuel tank overflow drain port is
unclogged to ensure free drainage and avoid exter-
nal water from entering the tank inner chamber.
Fuel tank filler
Specified upper
limit position
Shift lever
of fuel filler
This model of motorcycle is
Fuel tank sketch
designed with the normally
engaged six-speed interna-
tional gear (non-cyclic) shift
mode, which is operated as
shown. Hold firmly the clutch
lever and turn off the accelera-
tor while operating the shift
lever. The neutral gear position is located between
the gear position 1 and gear position 2. From the
neutral position, depress the shift lever to engage
the gear position 1. Move the lever upward once to
engage the next high-speed gear position; depress
the lever once to engage the next low-speed gear
position. For engaging the neutral position, depress
or move upward the shift lever to the position
14
Publicidad
