Publicidad
Idiomas disponibles
Idiomas disponibles
Engine oil level and oil change
Engine oil level
Check the engine oil level
before starting the engine.
When checking the oil level,
keep the motorcycle upright on a
flat ground and observe whether
the oil level is between the MAX
and MIN marks through the sight
glass. When the oil level is lower than the MIN mark 2,
open the upper oil filler cap 3 and add oil to a level
between the MAX 1 and MIN 2 marks.
A new motorcycle should be filled with 1.2L of
engine oil. For oil change, 1.0-1.1L engine oil
should be used.
Notice
Start the engine, keep the engine at idle speed for
a few minutes, and then turn the engine off.
Check again the oil level with the dipstick. The oil
level must be between the MAX and MIN marks
and no leakage is found from the engine.
Wipe to remove the splashed engine oil (if any).
Engine oil change
For draining engine oil, put a
collecting pan under the drain
bolt 4 on the lower right cor-
ner of the engine. Remove the
drain bolt, and reinstall it after
draining engine oil completely.
Notice
The engine oil change should be performed from a
hot engine and with the vehicle secured by a sup-
porting frame (ensuring that the motorcycle is level
and the vehicle body is upright) to ensure that the
engine oil can be drained quickly and completely.
Replacement of engine oil filter
Replace the engine oil filter
while replacing the engine oil
every time. For replacement of
engine oil filter, proceed as
follows:
26
Publicidad
