Publicidad
Idiomas disponibles
Idiomas disponibles
Oil level and oil change
Before starting the engine, check the
engine oil level. When checking the oil
level, let the vehicle stand upright on
the flat ground, and observe whether
the liquid level is between the scale
lines L and H through the oil peep
window. When the engine oil level is lower than the
lower scale line L, open the upper oil filler cap ① and
add engine oil to the middle position of the upper and
lower scale lines.
Replace the engine oil and the oil filter
Notice
The engine oil shall be replaced when the
temperature of the engine is not yet cooled and the
vehicle body is supported by the support frame (to
ensure that the motorcycle is on the horizontal
plane and the vehicle body is vertical), so as to
ensure that the engine oil is drained quickly and
completely.
The engine oil capacity is approxi-
mately 3.2 liters, or 2.9 liters when
replaced.
(1) When draining the engine oil,
properly place the oil drain basin
below the oil drain position, remove
the oil drain bolt ①, completely drain
the engine oil in the tank, reinstall the
oil drain bolt with a torque of 20 ~ 25 N. M, and
replace the engine oil filter ② according to the
following steps:
①. Use the special tool for removing the engine oil
filter to clamp the engine oil filter and rotate it coun-
terclockwise to remove the engine oil filter to be
replaced.
②. Clean the oil filter and the engine mounting
surface with a clean cloth.
30
Publicidad
