Publicidad
Idiomas disponibles
Idiomas disponibles
Turn the height adjusting screw ①
clockwise to lower the low beam
and high beam simultaneously;
turn the height adjusting screw ①
counterclockwise to raise the low
beam
and
high
simultaneously.
Notice
When adjusting the beam height, the driver should
sit on the seat cushion of the vehicle, with both tires
on the ground, and keep the vehicle in a vertical
state for adjustment.
ABS use and maintenance instructions
When the power lock is turned on, the ABS indicator
on the instrument panel will be on (not flashing),
which is normal. When the riding speed reaches
5km/H, the ABS indicator on the instrument panel
will go out, and the ABS is in normal working
condition.
beam
47
ABS lamp is on (not flashing), indicating that ABS is
in the diagnosis state.
If the ABS lamp is off, it indicates that the ABS is in
normal operation.
Flashing of ABS lamp indicates that ABS is not
working (or faulty).
If it is found that the ABS indicator keeps flashing, it
indicates that the ABS is not working. Please check
whether the ABS connector is installed in place and
whether the clearance between the ABS wheel
speed sensor and the gear ring is within the range of
0.5 ~ 1.5mm.
If the ABS wheel speed sensor is damaged, the ABS
indicator on the instrument panel will flash and the
ABS will not work. As the ABS wheel speed sensor
has certain magnetism, it may absorb some metal
substances. Please keep the ABS wheel speed
sensor clean and free of foreign matters. Adhesion
of foreign matters may cause damage to the ABS
wheel speed sensor.
For ABS system failure, please contact the local
QJMOTOR service station for repair.
Publicidad
