Publicidad
Idiomas disponibles
Idiomas disponibles
the battery). If the temperature of the battery is
higher than 45°C during charging, stop charging
immediately and charge again after the tempera-
ture drops.
2.The battery terminal red is positive and black
is negative. Turn off the power supply during
wiring, connect the positive electrode first and
then the negative electrode; remove the negative
electrode first and then the positive electrode
during disassembly.
3.Charging system test: After the vehicle is start-
ed, the battery voltage displays between 13.5 V
and 15 V, indicating that the charging system is
normal.
4. Vehicle leakage current detection: turn off the
power supply of the vehicle, connect the posi-
tive or negative pole in series with the multime-
ter (current gear), the current is less than 3mA,
and the vehicle circuit is normal.
5. When the motorcycle is not used for a long
time, it should be recharged once a month, or
the battery should be removed and placed sepa-
rately, and the voltage should be detected once
every three months. When the voltage is lower
than the 12.6 V, it should be recharged. It is not
allowed to store the battery in the state of lack of
electricity.
Take out the battery for inspection in the following
order:
a. Turn off the power switch of the motorcycle
b. Remove the seat cushion
c. Remove the battery pressure plate
d. First remove the negative terminal (-) and then
remove the positive terminal (+)
e. Take out the battery gently, and install the battery
in the reverse order.
Warning
When reinstalling the battery, make sure that the
battery leads are connected correctly. If the battery
wires are connected reversely, the circuit system
and the battery itself will be damaged. The red line
must be connected to the positive terminal (+) and
the black line must be connected to the negative
terminal (-).
44
Publicidad
