Publicidad
Idiomas disponibles
Idiomas disponibles
③. Use a new oil filter of the same type and apply a
layer of lubricating oil on the O-ring.
Notice
Do not remove the oil filter O-rings, as this will
cause them to be out of place, resulting in oil leaks
or engine damage.
④. Install the new engine oil filter on the engine by
hand until it can not be screwed by hand, and then
tighten the engine oil filter by a torque wrench with a
torque of 15 ~ 20 N.M.
(2) Fill the engine with engine oil that meets the
specification for about 2.9 L until the oil reaches the
middle position of the upper and lower scale marks.
(3) Install the oil filler cap.
(4) Start the engine, let the engine run at idle speed
for several minutes, and then turn off the engine.
(5) Check the oil level again. The oil level must
exceed the lower scale line and not exceed the
upper scale line. At the same time, there is no oil
leakage in the engine.
(6) If the engine oil is splashed, please wipe it clean.
Spark plug
Use a small wire brush or spark plug
cleaner to remove the carbon deposit
attached to the spark plug at the first
1000km of driving and every 6000km
thereafter, and use a spark plug gap
thickness measuring piece to readjust the
spark plug electrode gap to keep it
between 0.7 and 0.8mm.
Recommended spark plug model: CR8E
(NGK)
Caution
Do not overtighten the spark plug or stagger the
threads to avoid damaging the threads of the cylin-
der head. When removing the spark plug, do not
allow impurities to enter the engine through the
spark plug hole in the cylinder head.
31
0.7-0.8mm
Publicidad
