Fitting Carrying Eye (Clamp) - Stihl KW Manual De Instrucciones

English / USA
9
9
8
8
1
5
6
7
10
10
Mounting the Loop Handle
: Place the clamp (5) in the loop
handle (1) and fit handle in position
on the drive tube (6).
: Fit the clamp (7).
: Line up the holes.
: Fit washers (8) on the screws (9)
and insert screws through the holes.
: Screw on the square nuts (10) as far
as stop.
14
A
Aligning the Loop Handle
: Adjust the loop handle (1) to the
most comfortable position for the
user and application.
Distance A must not be more than
22" (55 cm).
About 14" (35 cm) is recommended.
: Tighten down screws on loop
handle firmly.
Fitting Carrying Eye*
(Clamp)
1
2
: For position of carrying eye (clamp)*
see "Mounting the Loop Handle".
: Position the clamp (1) so that the
tapped hole is on the left-hand side
of the drive tube (viewed from
powerhead).
: Squeeze the ends of the clamp
together and hold it that position.
: Insert M 6 x 14 screw (2).
: Line up the carrying eye.
: Tighten down the screw.
* see "Guide to Using this Manual"
1
1
KW