Other Settings; About Sleep Mode; Disabling Sleep Mode; Enabling Sleep Mode (Default Setting) - Boss LOOP STATION RC-30 DUAL TRACK LOOPER Manual Del Usuario

Other Settings

About Sleep Mode

When ten hours have elapsed since the last operation
or audio input, the RC-30 will enter sleep mode (power
conservation mode; only the bypass sound will be output).
From sleep mode, you can press the pedal to return to
normal mode.
* Battery power continues to be consumed even
in sleep mode. To prevent battery consumption,
turn off the power by removing the plug from the
OUTPUT L jack.
* The RC-30 will not enter sleep mode if there is a
phrase that has not been saved.

Disabling Sleep Mode

1. While holding down the left pedal, turn
on the power (insert a plug into the
OUTPUT L jack).
2. Continue holding down the left pedal
for five seconds.
The display will blink "
will blink.
3. Release the left pedal; the RC-30 will
resume normal operation.
Enabling Sleep Mode (default
setting)
1. While holding down the left pedal, turn
on the power (insert a plug into the
OUTPUT L jack).
2. Within two seconds after the display
appears, step on the left pedal two more
times.
The display will blink "
will blink.
After two seconds, the RC-30 will resume normal
operation; sleep mode will be enabled.
__ " and the POWER indicator
" and the POWER indicator
SL

Changing the Switching Order of

Recording g Overdubbing g Playback

When you press the left pedal, the RC-30 will switch its
operation in the order of recording g overdubbing g
playback (default setting) (p. 8). However, you can change
this so that the order is recording g playback g overdub-
bing (RC-20XL compatible).
1. While holding down the [TAP TEMPO]
button, turn on the power (insert a plug
into the OUTPUT L jack).
2. Use the [ ] / [ ] buttons to select the
desired mode.
Display Explanation
Operation will switch in the order of
Recording g Overdubbing g Playback
rd
(default setting).
Operation will switch in the order of
Recording g Playback g Overdubbing
rP
(RC-20XL compatible).
3. Press the [TAP TEMPO] button to return
to normal operation.

Formatting the Internal Memory

* When you format the RC-30's internal memory, all
phrase memories that were saved will be erased,
and cannot be recovered. Do not format the internal
memory unless the display indicates "
RC-30 has stopped operating correctly.
1. While holding down the [WRITE] button
and the [RHYTHM ON/OFF] button, turn
on the power (insert a plug into the
OUTPUT L jack).
The display will indicate "
2. Press the [RHYTHM ON/OFF] button
once again.
The display will blink "
3. Press the [WRITE] button; formatting of
the internal memory will begin.
The indication " FN " in the display will blink rapidly.
When formatting is completed, the RC-30 will return
to normal operation.
* Never turn off the power while "
rapidly.
Er " and the
FN . "
FN . "
FN " is blinking
17