Setting The Backlight Mode - Pioneer UDP-LX500 Manual De Instrucciones

07
• When disposing of the product, we
recommend you reset it to the factory default
setting to delete the data.

Setting the backlight mode

• Default setting : 01 (normal mode)
The backlight lighting pattern can be selected
from among four modes, in consideration of
convenience and battery service life.
Caution
• The setting may be restored to the default after
the batteries are replaced. If this happens, reset
it.
 Input the 2-digit code you want to set.
Press the number buttons (0 to 9) to input the
code while pressing
• 01 (normal mode) : The backlight is turned on
and off with the light button. After it lights, it
turns off auto-matically if no operation is
performed for 10 seconds.
• 02 (frequent lighting mode) : The backlight
turns on when any button on the remote
control is pressed. It is turned off with the light
button. After it lights, it turns off automatically
if no operation is performed for 10 seconds.
• 03 (eco mode) : The backlight is turned on and
off with the light button. After it lights, it turns
off automatically if no operation is performed
for 5 seconds.
• 04 (off mode) : The backlight does not turn on
even when the light button is pressed.
If the backlight LED lights for three seconds and
continues to flash, the setting has been
successfully completed.
If the backlight LED flashes, the setting has failed.
48
En
LIGHT.