Cleaning The Pickup Lens; Handling Discs; Storing Discs - Pioneer UDP-LX500 Manual De Instrucciones

Ocultar thumbs Ver también para UDP-LX500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning the pickup lens

The player's lens should not become dirty in
normal use, but if for some reason it should
malfunction due to dust or dirt, consult your
nearest Pioneer authorized service center.
Although lens cleaners for players are
commercially available, we advise against using
them since some may damage the lens.

Handling discs

Do not use damaged (cracked or warped) discs.
Do not scratch the disc's signal surface or let it get
dirty.
Do not load more than one disc into the player at
a time.
Do not glue paper or put stickers onto the disc, or
use a pencil, ball-point pen or other sharp-tipped
writing instrument. These could all damage the
disc.

❖ Storing discs

Always store discs in their cases, and place the
cases vertically, avoiding places exposed to high
temperatures or humidity, direct sunlight or
extremely low temperatures.
Be sure to read the cautions included with the disc.
❖ Cleaning discs
It may not be possible to play the disc if there are
fingerprints or dust on it. In this case, using a
cleaning cloth, etc., to wipe the disc gently from
the center toward the outer edge. Do not use a
dirty cleaning cloth.
Do not use benzene, thinner or other volatile
chemicals. Also do not use record spray or
antistatic agents.
For tough dirt, apply some water to a soft cloth,
wring out thoroughly, wipe off the dirt, then wipe
off the moisture with a dry cloth.
❖ Specially shaped discs
Specially shaped discs (heart-shaped, hexagonal,
etc.) cannot be used on this player. Never use such
discs, as they will damage the player.
❖ Condensation on discs
If the disc is moved suddenly from a cold place into
a warm room (in winter, for example), water
droplets (condensation) may form on the disc
surface. Discs will not play properly if there is
condensation on them. Carefully wipe off the
water droplets from the disc surface before using
the disc.
08
51
En

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido