Safety Rules; Generals - Promax OD-405 Manual De Instrucciones

USER'S MANUAL. OD-405/410B/411/415

2 SAFETY RULES

2.1

Generals

*
The safety can turn compromised if there are not applied the
instructions given in this Manual.
*
Use the equipment only on systems or devices to measure the negative
connected to ground potential or off-grid.
*
This is a class I equipment, for safety reasons plug it to a supply line
with the corresponding ground terminal.
*
This equipment can be used in Over-Voltage Category II installations
and Pollution Degree 1 environments (see 2.3.-).
*
When using some of the following accessories use only the specified
ones to ensure safety:
Power cord
Probes
*
Observe all specified ratings both of supply and measurement.
*
Remember that voltages higher than 70V DC or 33V AC rms are
dangerous.
*
Use this instrument under the specified environmental conditions.
*
The user is only authorized to carry out the following maintenance
operations:
Replace the mains fuse of the specified type and value.
On the Maintenance paragraph the proper instructions are given.
Any other change on the equipment should be carried out by qualified
personnel.
*
The negative of measure is at ground potential.
*
Do not obstruct the ventilation system.
*
Follow the cleaning instructions described in the Maintenance
paragraph.
Page 7 11-2011