Sleep Mode; Setting The Time And Date - Microlife 3BU1-5 Manual De Instrucciones

IB 3BU1-5(new address) 2003.8.21
Attention!
• After the battery warning appears, the device is blocked until the bat-
teries have been replaced.
• Please use «AAA» Long-Life or Alkaline 1.5V Batteries. The use of
rechargeable batteries is not recommended.
• If the blood pressure monitor is left unused for long periods, please
remove the batteries from the device.
Functional check:
Press and hold the 0/I (ON/OFF) button to test all the display
elements. When functioning correctly all segments appear.

4.2. Sleep mode

The device is designed to stay at the sleep mode as batteries are loaded.
In this mode, the time and user icon set will be displayed. You can con-
duct the following operations during this mode.
• Reading the set date Press the
TIMEbutton. The date set will be dis-
played for 2 seconds.
• Recalling the measurements Press the
MEMORY button. The measuring data
stored can be displayed. For more infor-
mation refer to the section on Memory
storage and recall.
• Printing the measuring data Please press
the PRINT button. The stored measure-
ments can be printed. For details, please
refer to the section on Printer Function.
8
8:42 AM Page 8

4.3. Setting the time and date

This blood pressure monitor incorporates an integrated clock with date
display. This has the advantage, that at each measurement procedure, not
only the blood pressure values are stored, but also the exact moment of
the measurement. After new batteries have been inserted, the clock
begins to run from the following setting: 2001-01-01 00:00 O'clock. You
must then re-enter the date and current time. For this, please proceed as
follows (Example: Entering 2001-06-20 Time 09:30 o'clock):
1)Press and hold the Time button for three
seconds. User 1 or 2 will begin flashing.
Press the Time button again briefly. Now
you can begin changing the time and
date.
2) The correct year can be entered by press-
ing the MEMORY button.
(Example: 1 x press)
1
3) Press the TIME button again. The display
now switches to the current date, during
mmHg
which the first character (month) blinks.
mmHg
MR
1
4) The corresponding month can now be
entered by pressing the MEMORY button.
Example: 6 x presses)
1
9