To Lubricate The Steering Cylinder; To Lubricate The Joint Bearing; To Lubricate The Hydrostatic Transmission Cable - Husqvarna P 524 Manual De Usuario

2. Lubricate the seat slides with engine oil.
To lubricate the throttle cable, choke
cable and lever bearings (P 524)
1. Remove the right side cover.
2. Lubricate the free ends of the cables, including the
ends near the engine, with engine oil.
3. Move the throttle control, choke control and the
controls for the cutting deck to their end positions
and lubricate the cables again.
4. Lubricate the joints, catches and bearings of the
controls for the cutting deck with engine oil.
5. Attach the right side cover.
To lubricate the hydrostatic
transmission cable
1. Lubricate the joints and bearings of the hydrostatic
transmission cable with engine oil.
242 - 003 -
2. Remove the rubber sleeve and lubricate the
hydrostatic transmission cable with engine oil.
3. Press the forward drive pedal 5 times and lubricate
the hydrostatic transmission cable again.
4. Attach the rubber sleeve.

To lubricate the steering cylinder

The steering cylinder has 2 grease nipples, one on each
end.
• Lubricate with a grease gun until grease comes out.

To lubricate the joint bearing

1. Lubricate the joint bearing of the articulation with a
grease gun until grease comes out.
39