To Remove The Cutting Deck - Husqvarna P 524 Manual De Usuario

5. Push the cutting deck into the equipment frame.
Make sure that the front guide plugs go in the
grooves on the equipment frame. The equipment
frame lock releases automatically.
6. Push the cutting deck in until the rear guide plugs
touch the bottom of the grooves on the equipment
frame.
7. Put the drive belt around the drive wheel for the
cutting deck and attach the cutting height cable.
8. Put the spring handle in the spring holder.
9. Attach the front cover.

To remove the cutting deck

1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
242 - 003 -
4. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck.
5. Release the clip on the front cover with the tool
attached to the ignition key, and remove the cover.
6. Pull the spring handle out from the spring holder to
loosen the drive belt tension.
7. Disconnect the cutting height cable.
8. Remove the drive belt and put it in the belt holder.
15