To Clean The Product; To Clean The Engine And The Muffler - Husqvarna P 524 Manual De Usuario

Maintenance
Replace the drive belt for the cutting deck
Replace the V-belt on the cutting deck
Examine the muffler and heat deflector
Examine the spark plug for damages and make sure
that the electrode gap is correct
Replace the spark plug
Do a check of and adjust the throttle cable (P 524 on-
ly)
Do a check of and adjust the choke cable (P 524 on-
ly)
Clean the cooling fins on the engine and the trans-
mission
Clean the engine and the transmission
Do a check of/adjust front and rear wheel speed
Do a check of the fuel hose. Replace it if necessary
Replace the oil in the transmission

To clean the product

CAUTION: Do not use a high-pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, put it in the servicing
position and hose it down with water.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
• Examine all lubrication points and lubricate if it is
necessary. Always lubricate the bearings after you
clean the product.
242 - 003 -
Daily, before After the
operation (10 first 25
hour intervals) hours
O

To clean the engine and the muffler

Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
Weekly Maintenance inter-
(40 hour val in hours
intervals)
100 200
O O
X
O
O
O O
O O
O
O
400
X
X
X
O
23