To Get A Good Cutting Result; Maintenance; Maintenance Schedule - Husqvarna P 524 Manual De Usuario

2. Press and hold the lock button (B).
3. Keep the button pressed and release the parking
brake pedal.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 23
Clean as given in
Clean the inner surface of the cutting deck, around
the blades
Clean around the engine and the muffler
Clean the hydraulic oil cooler
Make sure that the cold air intake of the engine is not
blocked
Make sure that the safety devices are not defective
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Examine the cutting deck for damages
Examine the blades in the cutting deck
Do a check of the parking brake
242 - 003 -
A
B
Maintenance
4. To release the parking brake, press the parking
brake pedal again.

To get a good cutting result

• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
44 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
cutting result also at a higher speed.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Daily, before After the
operation (10 first 25
hour intervals) hours
*
*
X
X
X
X
X
X
*
X
X
X
Technical data on page
Weekly Maintenance inter-
(40 hour val in hours
intervals)
100 200
X
X
400
21