Putting On The Harness; Connecting The Backpack Battery To The Power; Tool; Connecting To A Power Tool With An Integrated Socket - Stihl AR 2000 L Manual De Instrucciones

English

12.3 Putting on the Harness

WARNING
The operator must be able to remove the backpack battery
quickly in the event of an emergency. In an emergency,
open and remove the waist belt and chest strap quickly
before dropping the battery to the ground.
To ensure a proper fit:
► Put the backpack battery on your back.
► Fasten and adjust the waist belt (2) so that it rests
comfortably but securely on your hips.
► Fasten the chest strap (1) and adjust it so that it fits
comfortably but securely across your chest.
► Adjust the harness straps so that the back padding fits
firmly and securely against your back.
16
1
3
4
13 Connecting the Backpack Battery to the Power Tool
► Thread the end of the waist belt through the loops (3)
and (4).
► To remove the harness, open the quick-release fasteners
on the waist belt and chest strap and loosen the harness
straps by lifting the sliding adjusters.
To help reduce the risk of injury in the event of an
emergency, practice quickly opening the fastener on the
waist belt, loosening the shoulder straps and removing the
battery. To avoid damage, ease the battery to the ground
when practicing. Do not allow the battery to drop to the
ground and do not throw it.
13 Connecting the Backpack Battery to
the Power Tool
13.1 Connecting to a Power Tool with an Integrated
Socket
To connect the battery to a power tool with an integrated
socket:
► Line up the arrow on the connecting cord plug (1) with the
arrow on the power tool socket (2).
► Push the plug into the socket with steady, even pressure
until it is fully inserted. The battery and power tool are now
connected.
For further information on activating and operating the
power tool, see the instruction manual of the power tool
being operated with this battery.
2
1
0458-820-8621-A