Information Before You Start - Stihl SR 430 Manual De Instrucciones

English
Closing screw-type tank cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.
54

Information Before You Start

NOTICE
With the engine stopped and before
starting, check the air intakes between
the backplate and powerhead for
blockages and clean if necessary.
Control handle
1
2
1 Setting lever
2 Throttle trigger
3 Throttle trigger lockout
Functions of setting lever
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Stop position 0
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position. The ignition is again ready for
operation.
Throttle trigger limiter position
Travel of throttle trigger can be limited in
two stages:
a 1/3 throttle
b 2/3 throttle
To disengage the travel limiter,
Return the setting lever (1) to the
N
3
run position F.
Throttle lock
1)
The throttle trigger (2) can be locked in
any required position.
To disengage the lock:
Return the setting lever (1) to the
N
run position F.
1)
Not in all versions, country-specific
1)
a
b
1
1)
1
2
SR 430, SR 450