Starting / Stopping The Engine - Stihl FCS-KM Manual De Instrucciones

together with the thrust plate (4)
until the pin slips into position and
blocks the shaft.
Fit the combination wrench (5) on
N
the screw (6).
Loosen the screw clockwise (left-
N
hand thread) and take it out.
6
9
4
9
11
Remove the thrust washer (4).
N
Position the blade (9) on the thrust
N
plate (10).
WARNING
Collar (see arrow) must engage the
blade's mounting hole.
Fit the thrust washer on the
N
shaft (11) and block the shaft.
Fit the screw (6) in the shaft
N
counterclockwise and tighten it
down firmly.
FCS-KM
Starting / Stopping the
Engine
Starting the engine
To start the engine, basically follow the
instructions for use for the KombiEngine
or basic power tool!
10
Place the machine on the ground in
N
a secure position
The blade must not touch the ground or
any other objects – risk of accident!
Assume a firm stance – possibilities:
N
standing, bending or kneeling
Press the machine firmly against
N
the ground with the left hand – do
not touch the control elements on
the control handle while doing so –
see instruction manual for the
KombiEngine or basic power tool
NOTICE
Do not stand or kneel on the shaft!
WARNING
If the engine is started, the blade may
rotate as soon as the engine is running –
therefore blip the throttle trigger as soon
as the engine is running – the engine
begins to idle.
The other starting procedure is
described in the instruction manual for
the KombiEngine or basic power tool.
Switching off the engine
see instruction manual for the
N
KombiEngine or basic power tool
English
13