Astralpool WELLMA Manual De Uso página 41

Desired temperature:
This is the desired temperature and it is showed in the right side of the panel.
Press the ket "ºC" to change it using the keys + y - . Use the same key to
set the temperature if we do not press anything after 10 seconds it won't be
any change..
Timing device switch on/ switch off:
The equpment can be programmed to switch on or switch off after some
hours. Both temporizations are compatibles, thus we can set, for example, to
swith one after 3 hours during 8 hours.
Swith on timing device:
We access to it wiht the first key of the timer whether the equipment is
functioning or not. When pressed it asks as when we want to switch on the
equipment with a minimum of 30 minutes with the keys +,- , we change the
time with intervals of 15 minutes. To validate press the key and we see it is
switch on indicating there is a program in course. If we pressed againg it will
switch off, cancelling the program.
If we set a program while the bath is switch off, this will start inmediately
showing on the panel when it will start. Whereas if we do it with the bath
switch off it wouldn't start counting after the bath it is switched off.
Once the switch on programe is set, it won't repeat again until we set new
program to the bath.
Switch off timing device:
We acceed with the second key of the timer whether the bath is switch on
or off. When pressed it ask when we want to swith off the bath with a
minimum of 30 minutes with the keys + , - , , we change the time with
intervals of 15 minutes. To validate press the key and we see it is switch on
indicating there is a program in course. If we pressed againg it will switch
off, cancelling the program.
If we set a program while the bath is switch off, this will start inmediately
showing on the panel when it will start. Whereas if we do it with the bath
switch off it wouldn't start counting after the bath it is switched off.
Once the switch on programe is set, it won't repeat again until we set new
program to the bath.
Input and output panel:
In this panel we can see the state of the input and outputs. Access pressing
both keys during some seconds. In the diagram it is indicated the meaning
of the details showed in the panel:
12