Control Panel Instructions; Ventilation Control - Astralpool WELLMA Manual De Uso

CONTROL PANEL INSTRUCTIONS

Control panel operation:
1.-Switch on / Switch off
2.-"+" plus
3.-light
5.-"º©" adjusting temperature
6.-Aroma
7.-Switch on timing device
8.-switch off timing device
9.-Fans
General operation:
Function of the equipment:
--Control of water level boiler
--Bath temperature regulation
--Heating control

--Ventilation control

--Light control
--Timing device switch on/switch off
--Control of breakdown
Switch on/Switch off:
The equipment is started with the control key ON / OFF . It can be started
from a distance connecting a pulsation to the terminal of the generator.
Once it is function we will see in the control panel the medium temperature
by the left probe and the temperature desired on the right.
An animation with darts indicate that the bath is heating until it reach the
temperature desired. One it get the desired temperature it shows the
temperature and the animation disapear.
Light control:
The light of the bath it is switch on and off automatically with the equipment.
It can be controlled in an independent way whenever activating the
corresponding key.
Aroma control :
The aromatherapy it is activated automatically when the control panes is
switched on, whe can activate and desactive it every any moment.
If we press this key during some seconds, we acced to the configuration
menu, where we can select the seconds of aroma diffusion and afther the
space between diffusions in minutes. To activate the change pulse the
aroma key.
Ventilation control :
The ventilation is activated automatically when the equipment is swicthed
on it will switch off after 20 minutes of stopping the equipment so as to
eliminate the steam in the bath.
We do not have to stop its functioning but if it is necessary we can
desactivated pressing the key during some seconds. To switch on again
press the key.
11