Baby auto irbag top Manual De Uso página 29

5. Fasten the seat belt into the vehicle´s buckle until
it "clicks", making sure the child seat is properly
installed (3.9).
6. Tighten the lap belt and diagonal shoulder belt,
then place the red safety clip
shoulder belt tongue as near to the vehicle
anchor point as possible without touching it!
(3.9, 3.10, 3.11 & 3.12).
Make sure the vehicle's safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle's safety belt or prevent
the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as
described in the instructions.
Ensure that the belt has no slack.
4. iNSTalliNg CHilD SEaT. groUP 1.
installing the child seat forward facing can only be
maid if the child is more than 9 kg.
WarNiNg
1. To install as group 1, the seat must be in its most
upright position to adjust reclining angle of the
child seat, pull the control red handle
you until the desired position is achieved (3.1).
2. Take off the
press it inside you will hear a "click" (4.1).
3. Fit the child seat into the vehicle´s seat, making
sure it is firmly pressed against the vehicle seat
backrest (4.2).
4. Pass the lap belt through the
the seat backrest and fasten the safety belt to
the vehicle anchor point. You will hear a "click"
when properly fastened (4.3, 4.4, 4.5 & 4.6).
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
(O)
basic and change is postion, then
(N)
on the diagonal
(J)
towards
(i) (P)
and guides in
29