skilsaw SPT88 Instrucciones De Funcionamiento página 33

Auxiliary Fence
Making an Auxiliary fence
7 3/8"
1 ¼"
4 ½"
2 ½"
Certain types of molding need a fence-face
extension because of the size and position of
the workpiece.
Holes are provided in the fence to attach an
auxiliary fence. The auxiliary fence is used
with the saw in the 0° bevel position only.
1. Use a ¾" thick piece of wood (plywood is
preferred) to cut an auxiliary fence based
on the dimensions shown in Fig. 29a.
2. Place the auxiliary fence against the miter
saw fence (Fig. 29b). Check that the
auxiliary fence does not interfere with the
head assembly. Check for interference
between the auxiliary fence and the lower
blade guard. Adjust as necessary.
WARNING
fence and the saw-head components by
performing a dry run. Fence interference
can prevent proper saw operation and cause
injury and/or tool damage.
3. Mark the locations of the support holes on
the wood from the back side of the fence
(Fig. 29a).
4. Drill and countersink the holes on the front
of the auxiliary fence.
SAW OPERATIONS
8 ¼"
Check for interference
between the auxiliary
FIG. 29a
3"
24 ¾"
FIG. 29b
8 ½"
9 5/8"
1 1/8" 4 ½"
2 ½"
33