Saw Operations; Switch; Body And Hand Positions - skilsaw SPT88 Instrucciones De Funcionamiento

Switch

The switch has a secondary LOCK-OFF tab
that must be rotated to the left to be able to
depress the main power switch. Grasp the
main switch with your fingers and slide the
tab to the left. Then pull the main switch to
activate the saw. Release the switch to stop
the saw (Fig. 19).

Body and Hand Positions

WARNING
cutting easier and safer. Observe the
following instructions
WARNING
hands outside the "No Hands Zone". The
"No Hands Zone" is defined as the area
between the lines marked on the left and right
side of the base, including the entire table
and portion of the fence within these marked
lines. This zone is labeled by "No Hands"
symbols placed just inside the marked lines
on the base.
Hold the workpiece firmly to the fence to
•
prevent movement.
Keep hands in position until the trigger has
•
been released and the blade has stopped
completely.
Keep feet firmly on the floor and maintain
•
proper balance.
Follow the miter arm when mitering left or
•
right. Stand slightly to the side of the saw
blade.
Look through the lower guard if following a
•
pencil line.
Before making any cut, with the power off,
•
lower the blade to preview the blade path.

SAW OPERATIONS

Position your body and
hands properly to make
Never place hands near
the cutting area. Keep
FIG. 19
FIG. 20a
Correct Use
Correct Use
Incorrect Use
Incorrect Use
25