Maruyama MSW1012CE Manual Del Propietário página 16

 Feeding water directly from a water tap (faucet)
Caution
 Do not bend the water suction hose or pull it in the lateral direction. It may result in the hose
damage or burst.
 Insert the water suction hose to the faucet and secure the hose by tightening the hose band with a
screwdriver.
 If the outer diameter of the faucet is too large to insert the water suction hose, a coupler is required.
Water suction hose
 Self-priming water
 Tighten firmly the water suction strainer by hand to prevent the male hose thread loosening.
 Insert the water suction hose all the way into the male hose thread and secure the hose with the hose
band.
Male hose thread
Caution
 Clean the water suction strainer after each use.
 Prepare a water bucket, plastic container or other container that can be used as the water feed
container.
A container is recommended volume of 20 liters or more.
 Put the container on the ground of the same height as the machine, feed water using a hose connected
to a water tap. And then sink the water suction strainer to the bottom of the container.
 Suction of the water at the start, make sure that the water suction hose is less than the height of 15 cm
from the water level in the container.
Hose band
Water suction strainer
Water suction strainer
Within 15 cm from
Water feed container
Water suction hose
the water level
-14-EN
Hose band
Water suction strainer
Water suction hose
Water feed container