Maruyama MSW1012CE Manual Del Propietário página 9

 Never tie up the trigger of the spray gun with a string, wire, etc.
Make sure the water jet will stop in the moment the hand is
released. Tying up the trigger is extremely dangerous
because the water jet does not stop when the spray gun is
dropped.
Failure to do may result in serious injury.
 For greater control and safety, grasp the spray gun with both
hands at all times. Pull back and hold the trigger to operate
the machine. Release the trigger to stop the flow through the
spray nozzle.
 Make sure the lock out is engaged before starting the engine.
Otherwise, extremely dangerous high-pressure water jet may
occur suddenly.
 Make sure that the lock out is engaged when you release your
hand from the spray gun while working.
 How to engage the lock out;
Pull up on the lock out until it clicks into the slot.
 How to disengage the lock out;
Push the lock out down and into its original position.
 When leaving the machine unattended, be sure to stop the
engine and pull the trigger to release the water pressure from
system to prevent a sudden injection of high-pressure water.
 Make sure that the high-pressure hose is straightened during
operation. If the hose is pulled forcibly, it may be bent and
damaged. To prevent damage to the hose, straighten it before
use. Also check occasionally during work that the hose is not
bent.
 Do not move the machine by pulling the high-pressure hose.
Damage the hose, water leakage occurs and the machine
may tip over. It may cause injury or fire.
 Do not too close the spray nozzle to the cleaning surface
when the working. And do not stop the spray nozzle in the
same place. High-pressure water may damage the cleaning
surface.
 When cleaning painted surfaces or mortar finished surface, be
sure to do the cleaning test. If not, it may damage the cleaning
surface.
 Keep the machine dry (do not use in the rain, do not splash
water to the unit). It may cause breakdown.
 Never direct a water jet stream towards people or animals or
place any body part in the stream. Leaking hoses and fittings
may also cause injection injury. Do not hold hoses or fittings.
 Do not inhale the mist generated during cleaning, it may be
harmful. Wear a protective mask if necessary.
(4) Precautions after use
 Inspect and maintain the protective gears so that they function properly at all times.
 Thoroughly remove water droplets, mud, dirt, etc., from the machine. If they remain attached, rust or
breakdown may occur.
 Wait for each part has sufficiently time to cool before performing any maintenance and inspection. Failure
to do so may cause burns.
 Never store the machine with fuel in the fuel tank inside a building where ignition sources are present,
such as water heaters and stoves, clothes dryers, and the like. Be sure to store the machine in a dry and
covered, no fire sources location. Place the machine in location that is not affected by the weather, such as
hanger or barn.
 It is important to store this machine in a frost-free area. Always empty water from all hoses, the pump, and
the spray gun before storing. If water remains, it may freeze and cause damage. Be careful in winter
season.
-7-EN
Never tie up the trigger!
Lock out the trigger
when starting the engine!
Do not bend the high-pressure hose!