Maruyama MSW1012CE Manual Del Propietário página 17

 Assembling the spray gun
Warning
 Securely connect the spray gun and spray
wand. If not, the spray wand may fly off,
cause accidents or injuries.
 Straight into the spray wand to the
spray gun, tighten firmly by hand by
turning clockwise the swivel of the
spray gun.
 If the spray wand is not plugged into
smoothly, apply a small amount of
water or diluted detergent to the inner
diameter part of the connection
thread.
Caution
 Do not touch the male thread at the connection part with bare hands. It may cause injuries. Wear
protective gloves when connecting the thread.
 Installing the high-pressure hose
Warning
 Securely connect the high-pressure hose. If the hose is disconnected, accidents and injuries may
occur.
Caution
Do not touch the male thread at the connection part with bare hands. It may cause injuries. Wear
protective gloves when connecting the thread.
 Remove the bending and twisting of the high-pressure hose.
 Straight into the high-pressure hose to the pump discharge port and spray gun connection port, and
tighten firmly by hand by turning clockwise swivel of the high-pressure hose.
 If the high-pressure hose is not plugged into smoothly, apply a small amount of water or diluted
detergent to the inner diameter part of the connection thread.
 If the connected high-pressure hose is twisted, remove the twists by extending the hose straight while
turning the spray gun.
 If the connected high-pressure hose is still twisted, loosen the swivel on the spray gun side and extend
the hose straight once again by turning the spray gun.
 When the high-pressure hose is free from twists, re-tighten the swivel.
Pump
discharge
port
High-pressure hose
Swivel
-15-EN
Spray gun Swivel Spray wand
Spray gun
Swivel
High-pressure hose