Yamaha 9.9F Manual Del Propietário página 156

Ocultar thumbs Ver también para 9.9F:
Tabla de contenido

Publicidad

602052
5
4
3
2
1
602042
602053
4-21
EML18010
Removing the Propeller
1) Using the pliers provided, straighten
the cotter-pin and pull it out.
2) Remove the propeller nut and washer.
3) Remove the propeller and thrust
washer.
1 Thrust washer
2 Propeller
3 Washer
4 Propeller nut
5 Cotter pin
EML19010
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing propeller, otherwise,
lower case and propeller boss may be
damaged.
8 Be sure to use a new cotter pin and
bend the ends over securely. Other-
wise, the propeller could come off dur-
ing operation and be lost.
1) Apply Yamaha Marine grease or a
corrosion resistant grease to the pro-
peller-shaft.
2) Install the thrust washer and propeller
on the propeller-shaft.
3) Install the washer and tighten the pro-
peller nut to the specified torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the pro-
peller shaft hole. Insert a new cotter pin
in the hole and bend the cotter pin
ends.
NOTE:
When the propeller nut does not align
with the propeller shaft hole after tighten-
ing to the specified torque, then tighten
the nut further to align it with the hole.
GB

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

13.5a15f

Tabla de contenido