Energy Yield; Fan; Arc Detection - Fronius Primo 208-240 3.8-1 Manual De Instrucciones

Energy Yield

The following settings can be changed/performed:
-
-
-
-
Setting range
Meter deviation/calibration
Meter calibration
Currency
Set the currency
Setting range
Feed-in tariff
Set the charge rate for the remuneration for energy fed into the grid
Setting range
Factory setting
CO2 factor
Set the CO2 factor for the energy fed into the grid

Fan

for checking the fan functionality
Setting range
-
-
-

Arc Detection

for checking arc detection/interruption
Setting range
32
Meter deviation/calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in Tariff
3-digit, A-Z
2-digit, 3 decimal places
(depends on the country setup)
Test fan #1 / Test fan #2
Use the "Up" and "Down" keys to select Test fan #1
Press the "Enter" key to start testing of the fans
The fans run until the menu is exited by pressing the "Esc" key
ArcDetector Status/Start Self-test