Energy Yield; Fan - Fronius Symo Advanced 10.0-3 208-240 Manual De Instrucciones

Since contrast depends on temperature, it may be necessary to adjust the 'Contrast'
menu item when environmental conditions change.
Illumination
Preset the inverter display illumination
The 'Illumination' menu item only applies to the inverter display background illumination.
Setting range
Factory setting

Energy Yield

The following settings can be changed/performed:
-
-
-
-
Setting range
Meter deviation/calibration
Meter calibration
Currency
Set the currency
Setting range
Feed-in tariff
Set the charge rate for the remuneration for energy fed into the grid
Setting range
Factory setting
CO2 factor
Set the CO2 factor for the energy fed into the grid

Fan

to check the fan functionality
Setting range
-
-
-
AUTO / ON / OFF
AUTO
AUTO: The inverter display illumination is activated by pressing any key. If no key
is pressed for 2 minutes, the display backlight goes out.
ON: The inverter display illumination is permanently on when the inverter is ac-
tive.
OFF: The inverter display illumination is permanently off.
Meter deviation/calibration
Currency
Feed-in tariff
CO2 factor
Currency / Feed-in Tariff
3-digit, A-Z
2-digit, 3 decimal places
(depends on the country setup)
Test fan #1/test fan #2 (depending on the device)
Select the desired fan using the 'Up' and 'Down' keys
Pressing the 'Enter' key starts the test for the selected fan.
The fan runs until the menu is exited by pressing the 'Esc' key.
41