Specifications - Sony Game Sync Mixing FST-ZX8 Manual De Instrucciones

Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do not
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or alcohol.
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the tape tab from side A or B as
illustrated.
Break off the
cassette tab
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a tape in the tape deck
Take up any slack in the tape deck. Otherwise, the tape
may get entangled in the parts of the tape deck and
become damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as playback, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use. Be
sure to clean the tape heads before you start an
important recording or after playing an old tape. Use a
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
tape.
Demagnetising the tape heads
Demagnetise the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetising tape. For
details, refer to the instructions of the demagnetising
tape.

Specifications

Amplifier section
FST-ZX8
Mexican models:
The following measured at AC 127 V, 60 Hz
DIN power output (rated): 140×2 + 140×2 watts
Continuous RMS power output (reference):
Other models:
The following measured at AC 120, 220, 240 V,
50/60 Hz
DIN power output (rated): 140×2 + 140×2 watts
Continuous RMS power output (reference):
FST-ZX6
Mexican models:
The following measured at AC 127 V, 60 Hz
DIN power output (rated): 220 + 220 watts (4 ohms at
Continuous RMS power output (reference):
Other models:
The following measured at AC 120, 220, 240 V,
50/60 Hz
DIN power output (rated): 220 + 220 watts (4 ohms at
Continuous RMS power output (reference):
Inputs
PHONO IN (phono jacks):
MIC (phone jack):
GAME INPUT AUDIO L/R (phono jacks):
GAME INPUT VIDEO (phono jack):
(6 ohms at 1 kHz, DIN)
180×2 + 180×2 watts
(6 ohms at 1 kHz, 10%
THD)
(6 ohms at 1 kHz, DIN)
180×2 + 180×2 watts
(6 ohms at 1 kHz, 10%
THD)
1 kHz, DIN)
280 + 280 watts (4 ohms at
1 kHz, 10% THD)
1 kHz, DIN)
280 + 280 watts (4 ohms at
1 kHz, 10% THD)
sensitivity 3 mV,
impedance 47 kOhms
sensitivity 1 mV,
impedance 10 kOhms
sensitivity 250 mV,
impedance 47 kOhms
1 Vp-p, 75 ohms
continued
GB
41