Brother MFC845CW Manual De Servicio página 104

Error Code
(Hex)
E0-E1
Not used
Wired LAN MAC address
E2
not registered. *1
E3 Wired LAN MAC
address not registered *2
E4-E5
Not used
E6
Write error in EPROM
E7
Not used
E8
Data scanning error during
transmission
E9 Not used
EA
Document removed at
phase B. *
EB-F6
Not used
F7
Memory card connection
failure
F8
Battery harness connection
failure (For models with
backup battery)
(Available in the maintenance
mode only)
F9-FF
Not used
1
*
For wired LAN-enabled models
2
*
For wireless LAN-enabled models
3
*
Phase B: FAX negotiation stage between sending machine and receiving machine
Symptom
Main PCB defective
3
4-17
Probable Cause
MAC address not
registered correctly
MAC address not
registered correctly
CIS defective
Main PCB defective
Document front sensor
actuator caught on the
surrounding parts
Document front sensor
defective
Main PCB defective
Memory card
inserted into the card
slot properly
Battery harness not
inserted correctly.
Solution
Replace the main PCB
Replace the WLAN
PCB
Replace the main PCB
Replace the scanner cover
(scanner unit)
Replace the main PCB
Correct the surrounding
parts on which the actuator
caught.
Replace the document
front sensor PCB
Replace the main PCB
Reinsert the memory
card.
Correct the connection
Confidencial