Installing.disc.brake.rotor; Installing.brake.lever - Magura MT 7 Manual De Instrucciones

Installing disc brake rotor
Loss of insurance protection with S-Pedelecs (E-bikes up to 45 km/h)
that require insurance.
Use only original MAGURA brake pads and disc brake rotors

which have the ECE or KBA test certifications for vehicle compo-
nents subject to approval.
Never change the size of the disc brake rotors.

Danger of accident due to brake failure or sudden brake
lock-up due to excessive load.
Never mount disc brake rotors on S-Pedelecs, Pedelecs,

Cargo bikes or Tandems.
To install a Centerlock™ hub, the MAGURA
L
Centerlock adapter is required.
Place disc brake rotor on the axle flange.
)
The direction arrows point in the direction of forward movement.
Ö
[ ]
a5
Make sure that all retaining screws (not lock ring!) are coated
)
with fresh screwlock (medium strength).
Screw in retaining screws 2–3 threads.
)
Turn disc brake rotor clockwise to the stop.
)
Tighten retaining screws crosswise with tightening torque of
)
4 N·m (35 lbf·in). [ ]
a5
Tighten lock ring with tightening torque of 40 N·m (354 lbf·in).
)
Thoroughly degrease the disc brake rotor using brake cleaner or
)
spirits.
Always use new brake pads if new disc brake rotors are installed.
)
InstallatIon
Installing brake lever
Before installing your brake decide which brake lever blade (right
L
or left) you want to allocate to your front wheel or rear wheel
brake.
Make sure that the size of your handlebar (clamping Ø brake
)
lever) fits your brake lever – see
Push the brake lever onto the handlebar.
)
Arrows (thick end of the clamp) point upwards!
Ö
First tighten the upper clamping screw
)
with tightening torque of 4 N·m (35 lbf·in).
The clamping screw is in contact at the top, there is a gap at the
Ö
bottom!
The brake lever can be rotated by hand when forced. This reduces
L
the danger of irreparable damage to the brake lever or handlebar
in the event of a crash.
If you reverse the position (right or left) of your brake levers, you
L
can easily change the position of the rotating dial (BAT) or cover
without tools so they are still on top.
Press the locking disc
)
spring .
5
( )
Pull and hold brake lever blade lightly.
)
Pull out rotating dial (BAT)
)
Position clamp spring with locking disc, press and rotate 90°.
)
[ ]
a5
, page 21.
D –
imensions assemBly
[ ]
a3
, then the lower one
2
( )
[ ]
a4
, rotate 90° and remove it with the clamp
4
( )
or cover and replace from above.
6 7
( ) ( )
3
( )
25