Magura MT 7 Manual De Instrucciones página 34

Insert the bleeding syringe
3
) ( )
Press MAGURA Royal Blood slowly out of the filling syringe
)
through the brake system – tap lightly on the brake cylinder and
brake lever during this process.
Flick the brake lever blade 2–3 times.
)
This dislodges air bubbles and they rise into the bleed
Ö
syringe [ ].
h4
3
( )
Continue the process until you cannot see any more air bubbles.
)
The brake system has been bled.
Ö
Oil loss when removing the bleed syringe.
Have a clean cloth at hand.

Hold the bleed bore closed before and after pulling off of the

bleeding syringe.
Hold the bleeding syringe with its point upwards after pulling off,

and push in the piston until just beyond the bleed bore.
Pull the bleeding syringe out of the bleed hole.
)
Press a little MAGURA Royal Blood slowly out of the filling syringe
)
through the brake system until the bleed hole is just filled.
Screw the EBT screw into the bleed hole and tighten with tight-
8
( )
)
ening torque of 0.5 N·m (4 lbf·in).
Oil loss when unscrewing the filling syringe.
Have a clean cloth at hand.

After unscrewing close the filler hole quickly.

Before unscrewing, lift the brake calliper above the level of the

brake lever, if possible.
Unscrew the barbed fitting of the filling syringe
)
hole. [ ]
h2
Screw the screw plug quickly into the filler hole and tighten with
)
tightening torque of 4 N·m (35 lbf·in)
Remove any oil residues thoroughly.
)
34
MaIntenanCe
tightly into the bleed hole
[ h4 ].
2
( )
[ ]
h3
from the filler
2
( )
[ ].
h2
Pull and hold the brake lever blade several times and check:
)
No oil is leaking from any part of the brake system.
Pressure point is clearly noticeable and does not change.
Install brake pads – see
)
Install wheel with mounted disc brake rotor or insert transport
)
device.
[ ]
D1
Move the brake lever into the customary position and secure
)
– see , page 25.
installing brake lever
Set the pressure point – see
)
2
( )
, page 32.
c
hanging Brake paDs
, page 29.
setting the pressure point