Troubleshooting/Repair - Nikon MONARCH 7i VR Manual De Instrucciones

En
Model
Es
Laser
Fr
Laser classification
Pt
Wavelength (nm)
Pulse duration (ns)
Output (W)
Beam divergence (mrad)
* Waterproof models
This Nikon Laser Rangefinder is waterproof, and will suffer no damage to the optical system nor observation if submerged
or dropped in water to a maximum depth of 1 meter/3.3 feet for up to 10 minutes.
The Nikon Laser Rangefinder offers the following advantages:
• Can be used in conditions of high humidity, dust and rain without risk of damage to internal functions.
• Nitrogen-filled design makes it resistant to condensation and mold.
Observe the following when using the Nikon Laser Rangefinder:
• The unit is not a sealed structure, so it should not be operated nor held in running water.
• If any moisture is found on movable parts of this equipment, stop using it and wipe it off.
** The battery chamber is rainproof, not waterproof. Water may enter the device if the Rangefinder is submerged in water. If
water enters the battery chamber, wipe out any moisture and allow time for the chamber to dry.
Battery life
Continuous operation: Approx. 3,300 times (at approx. 20°C)
This figure may differ according to conditions such as temperature and other factors. Use only as a guide.
・ The battery supplied with this Nikon Laser Rangefinder is for operation checking. Due to natural electrical discharge, the life of
this battery will likely be shorter than that noted above.
・ If water enters the battery chamber due to submersion, dry the battery chamber well, then replace the battery.
20
MONARCH 7i VR
IEC60825-1: Class 1M/Laser Product
FDA/21 CFR Part 1040.10:Class I Laser Product
905
9
20
Vertical: 1.8, Horizontal: 0.25
￭ Troubleshooting/Repair
If the Nikon Laser Rangefinder fails to function as expected, check the list below before consulting
your local dealer or the store where you purchased it.
● If there is a problem with the product.
Problem
・Press the PWR button (top of the body).
・Does not turn on ・Check battery is inserted correctly.
・Replace the battery with a new one.
・Confirm each mode setting.
・Unable to measure ・Confirm if it can measure a large target close to you (example: a building
・Anomalous result
approx. 15m/yd. ahead of you).
・Clean the lens surface if necessary.
・Compare the vibration of the target in the viewfinder when the Laser
・Do not know if the VR
Rangefinder is ON and OFF.
(Vibration Reduction)
・ While the Laser Rangefinder is ON, the VR (Vibration Reduction) function is
function is working
always activated.
・The VR (Vibration Reduction) function is activated concurrently when
・ Cannot turn off the VR
the Laser Rangefinder is ON. When the Laser Rangefinder is OFF, the VR
(Vibration Reduction)
(Vibration Reduction) function automatically turns off.
function
・The VR (Vibration Reduction) function cannot be switched on and off.
・There are minute motion ・Due to the VR (Vibration Reduction) system motor, minute motion
sounds when the power sounds occur. These sounds are normal, please continue to use the Laser
turns on and off Rangefinder.
・ Failure indication. Please contact your local dealer or the store where you
・[ ] is displayed in the
internal display purchased the product.
Cause/Solution
21
En
Es
Fr
Pt