Correcting Vertical Mitre Angles - Festool KAPEX Serie Manual De Instrucciones

9.3

Correcting vertical mitre angles

If the actual value no longer corresponds with
the preset value, you can correct this value ac-
cordingly:
– Engage the saw unit in the 0° position.
– Open both screws (23.1).
– Swivel the saw unit until the actual value is 0°.
You can check this by setting an angle between
the saw table and the saw blade.
– Tighten the two screws (23.1) again.
– Check the angle setting by making a test cut.
If the pointer (22.2) no longer rests on the preset
value, you can loosen the screw (22.1) and readjust
this value.
9.4 Replacing the tabletop insert
Never work with a worn table insert (20.1), replace
it with a new one.
– To replace the table insert, unscrew the six
screws (20.2).
9.5 Cleaning or replacing window for laser
(KS 120 EB only)
The window (21.2) for protecting the laser can
become dirty during operation. It can be removed
for cleaning or replacement.
– Release the screw (21.5) by approx. 2 rota-
tions.
– Press the window at the same time in the direc-
tions (21.3) and (21.4).
– Remove the window.
– Clean the window or replace it with a new one.
– Fit the cleaned/new window. Both of the pegs
(21.1) on the window must snap into the recesses
of the upper hood as shown in Fig. 21.
– Tighten the screw (21.5).
10 Disposal
Do not throw the power tool in your household
waste! Dispose of the machine, accessories and
packaging at an environmentally-responsible
recycling centre! Observe the valid national regu-
lations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh:
www.festool.com/reach
23