Descrizione Del Prodotto; Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Apex Domus 4 Manual De Instrucciones

Italiano

2. DESCRIZIONE DEL PRODOTTO

2.1 SISTEMA POMPA E MATERASSO
1
3
1. CPR
2. Unità della pompa
3. Sistema Materasso
4. Connettore rapido
2.2 UNITÀ DELLA POMPA
2
1
1
2
2
4
Parte anteriore
1. Connettori rapidi
2. Pannello anteriore
3
Parte posteriore
1. Pulsante di alimentazione
2. Cavo di alimentazione
3. Staffe di montaggio
106
English
70 % U (30 % dip
T
in U )for 25 cycles
T
<5 % U (>95 %
T
dip in U )for 5 sec
T
Power frequency
(50/60Hz) magnetic field 3 A/m
IEC61000-4-8
NOTE: U is the a.c. mains voltage prior to the application of the test level
T

Guidance and Manufacturer's Declaration - Electromagnetic Immunity:

This device is intended for use in the electromagnetic environment specified below. The user of this
device should make sure it is used in such an environment.
Immunity Test IEC60601 test level Compliance Electromagnetic
Conducted RF 3Vrms150 kHz to
80 MHz outside ISM
IEC 61000-4-6
bands a
Radiated RF
IEC 61000-4-3
3 V/m 80 MHz to
2.5 GHz
70 % U (30 % dip recommended that the device
T
in U ) for 25 cycles be powered from an
T
uninterruptible power supply or
<5 % U (>95 %
T
a battery.
dip in U ) for 5 sec
T
Power frequency magnetic
fields should be at levels
3 A/m characteristic of a typical
location in a typical commercial
or hospital environment.
Environment-Guidance
Portable and mobile RF
communications equipment should
be used no closer to any part of this
device, including cables, than there
commended separation distance
calculated from the equation
applicable to the frequency of the
transmitter.
Recommended separation distance

150kHz to 80MHz
d 1 2 . P
3 Vrms

150kHz to 80MHz
d 1 2 . P

80 MHz to 2.5G MHz
d 2 3 . P
Where P is the maximum output
power rating of the transmitter in
watts (W) according to the
3 V/m
transmitter manufacturer and d is
the recommended separation
b
distance in meters (m).
Field strengths from fixed RF
transmitters, as determined by an
c
electromagnetic site survey , should
be less than the compliance level in
each frequency range d .
15