Connection Of High-Pressure; High-Pressure Range; Low-Pressure Range; Protective Cap For Push-In Type Fittings - Lincoln Quicklub SSV D Instrucciones De Funcionamiento

User Manual
Operating Instructions
Tube Fittings, Push-in Type, continuation
Connection of High-pressure Hose and Pressure Plastic Tube
Fig. 4 Check valve with reinforced collet and hose stud
Fig. 5 Check valve with knurled collet and pressure plastic tube
Fig. 6 Push-in type fitting with protective cap
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Installation, continuation
High-pressure range (main metering device)
4156a98
Low-pressure range (secondary metering device)
Connect the pressure plastic tube (ø 6x1.5 mm) to the check
valve with standard collet (knurled collet) and to the inlet
fittings towards the lubrication point (knurled collet).
The pressure plastic tubes are marked with white lines
(Fig. 5) as an installation aid.
4157a98
Cut the pressure plastic tube off at one of the white lines
before it is mounted. Then insert the pressure plastic tube
into the fitting up to the next white mark.
This will ensure a correct installation of the pressure plastic
tube in the tube fitting.

Protective cap for push-in type fittings

Push-in type fittings, check valves and pressure relief valves
can be closed with a protective cap in order to avoid contami-
nation.
Designation ........................................................... Part No.
Protective cap ...................................................432-24313-1
00002632
IMPORTANT
Only main lines (NW 4.1 x 2.3 mm) with
threaded sleeve and hose stud may be
connected to the inlet fitting and the check
valves with reinforced collar.
6001a02
NOTE
Special cases, such as applications for
construction machines or agricultural ma-
chines, require the use of check valves
and inlet fittings (towards the lube point)
6001a02
with reinforced collet also for the low-
pressure range. Refer to Parts Catalog.
2.2A-20003-B07
Page 5 of 26