Tube Fittings, Push-In Type (Main Or Secondary Metering Devices) - Lincoln Quicklub SSV D Instrucciones De Funcionamiento

User Manual
Operating Instructions
Adapting the Lubricant Output by Cross-porting of Outlets , continuation

Tube fittings, push-in type (main or secondary metering devices)

Fig. 27 Install the push-in type outlet fittings and the closure plugs in accordance with the dosage
2 - Delivery hole of the metering piston
and control piston
4 - Closure plug (M11 x 1),
piston (with chamfer)
9 - Junction channel
NOTE
In the case of construction machines or
agricultural machines use high-pressure
hoses for the lubricant feed lines. In this
case, secondary metering devices (see
6001a02
Fig. 27) must also be equipped with check
valves with reinforced collet (standard
flange, see page 4).
Single lubricant output
The simple lubricant output is the lubricant quantity dispensed
by a pair of pistons (metering and control piston) per stroke
and per outlet bore to one lubrication point (see page 22,
Tab. 2).
Multiple lubricant outputs
Close one or more outlets to increase the output of the outlet
below. Depending on the dosage (page 8, paragraph „Meter-
ing Screws") several outputs add up (see fig. 28).
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Operation, continuation
10 - Closure plug with hex. socket head
11 - Inlet fitting
(optional with protection cap)
1)
Outlets, left-hand side
Delivery
Fig. 28
A -
Delivery 8 = dosage 10 + dosage 8
Delivery 2 = dosage 4 + dosage 2
Delivery 1 = dosage 5 + dosage 3 + dosage 1
12 - Valve body assembly
Main metering device
1)
Secondary metering device
when desired
No. Dosage
Dosage of multiple outputs
clamping ring (brass)
2.2A-20003-B07
1203b05
- with reinforced collet
- with knurled collet
Outlets, right-hand side
Delivery No. Dosage
1014b05
Page 19 of 26