Before You Extend Or Convert The Cd01-Pi - Aventics CD01-PI Instrucciones De Servicio

AVENTICS | CD01-PI | R412012449–BAL–001–AD

10.3 Before you extend or convert the CD01-PI

If you extend the CD01-PI:
1. make sure the relevant system part with the built-in
CD01-PI is not under voltage or pressure.
2. Remove all pneumatic and electrical connections.
3. Remove the CD01-PI from the mounting surface or DIN rail
(see section 8 "Disassembly" on page 82).
If you wish to replace components that are mounted on the base
plates:
make sure the relevant system part with the built-in
CD01-PI is not under voltage or pressure.
The pneumatic and electrical connections can remain in
place. You do not need to detach the CD01-PI from the
DIN rail or mounting surface.
Extension and Conversion
85