Fuse Replacement; Suction Inlet Disassembly/Assembly - Nilfisk Advance RS 1300 Instrucciones De Uso

Rear wheel removal/installation
11. Place a jack (6, Fig AW) under the relevant housing (9) in the rear axle (7), as shown in the fi gure.
WARNING!
The jack (6, Fig. AW) is not part of the machine equipment. Use a suitable jack with a minimum lifting capacity of
6,614 lb (3,000 kg).
12. Activate the jack (6, Fig. AW) carefully, and lift the wheel (8) until it is slightly detached from the ground.
13. Unscrew the mounting nuts and remove the wheel (8, Fig. AW).
14. Install the wheel (8, Fig. AW) by performing steps 11 to 13 in the reverse order.
Wheel mounting nut tightening torque: 295 lb·ft (400 N·m).

FUSE REPLACEMENT

1. Engage the parking brake (13, Fig. E).
2. Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
3. Turn counter-clockwise and remove the key of the battery release device (47, Fig. F).
4. Remove the electrical component protection panel (19, Fig. E) and then check the fuses inside the electrical panel (3) (See
Electrical Panel Functions paragraph). Only the F1.1 fuse (46, Fig. F) is placed directly on the battery positive terminal (34).
Then replace the relevant fuse among those shown in Electrical Fuses paragraph.

SUCTION INLET DISASSEMBLY/ASSEMBLY

NOTE
This is a basic procedure, it is often recalled during other procedures, when necessary.
Disassembly
1. Remove the side brooms (see the procedure in the relevant paragraph).
2. Move the 3rd broom (21, Fig. G) aside, and lower the suction inlet (17) according to the procedure shown in the relevant
paragraph.
3. Engage the parking brake (13, Fig. E).
4. Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
5. Mark the position of the pipes (1 and 2, Fig. BB) (for proper assembly), then disconnect them from the suction inlet (3) and
plug them.
6. Mark the position of the pipes (4 and 5, Fig. BB) (for proper assembly), then disconnect them from the suction inlet (3) and
plug them.
7. Disconnect the dust control system pipes (6 and 7, Fig. BB).
8. Disconnect the connectors (8 and 9, Fig. BB) and remove the gasket.
9. Remove the screws (10, Fig. BB).
10. Move the suction inlet (3, Fig. BB) forward, and loosen the suction pipe clamp (11).
11. Disconnect the suction pipe (12, Fig. BB) from the suction inlet.
12. On both sides of the suction inlet, unscrew the nuts (13, Fig. BB) and disconnect the relevant springs.
13. Remove the suction inlet (3).
14. Collect the pipes (15, Fig. BB) disconnected from the suction inlet, and secure them with clamps (14).
Fit a dust boot to prevent dirt and foreign material from entering the pipes (15).
Assembly
15. Assemble the components in the reverse order of disassembly.
16. If necessary, check the suction inlet and skirt height and operation (see the procedure in the relevant paragraph).
INSTRUCTIONS FOR USE
RS 1300 33018312(3)2010-01
ENGLISH
49