Safety Functions - Nilfisk Advance RS 1300 Instrucciones De Uso

ENGLISH

SAFETY FUNCTIONS

The machine is equipped with the following safety functions.
Reverse gear buzzer
The machine is equipped with a sensor and a buzzer to indicate that the machine is moving in reverse.
Broom speed limiter
The machine is set in order to stop the hydraulic functions if the engine exceeds 2,050 rpm.
Joystick safety push-button
The push-buttons on the joystick are active only if the safety push-button (on the joystick) is pressed.
Safety device for control sequence during broom start-up
The suction inlet lower only when the broom switch is pressed.
Sensor for engine start-up inhibition when the drive pedal is pressed
The machine is equipped with a sensor that does not allow for engine start up when the drive pedal is pressed.
Manual battery release
The machine is equipped with a manual battery release device to protect the machine when it is stored for long periods or when it is
left unattended.
Sensor for engine start-up inhibition when the operator is not on the driver's seat (optional)
The machine is equipped with a sensor that does not allow for engine start up when the operator lifts from the driver's seat for more
than 2 seconds. The same sensor prevents the brooms from lifting/lowering, the machine from moving (the machine cannot move in
any direction) and disables the accessories.
Hopper lifting buzzer
The machine is equipped with a buzzer that sounds when the hopper is lifting.
Emergency push-button
The machine is equipped with an emergency push-button to stop the engine in case of immediate danger.
52
INSTRUCTIONS FOR USE
33018312(3)2010-01 RS 1300